Or When the car is moving (above 3mph) the full throttle shift setting will be used. So when the car in stationary the setting for launch control will be used say 3500rpm, I wire my micro switch so that when my clutch is pressed it activates my micro switch allowing 12v to go to E22, this tells the ECU that the clutch is pressed in, So say i want to use E22 brake switch (12v on) I have read numerous posts on here about questions on how to get it working 100%īasically you need to tell te ECU when the clutch is pressed in, For example putting a switch under your clutch pedal, so that when you press it you activate the switch to either send or cut 12v to one of the ECU pinouts specified in the parameters clutch switch drop down section, Ive put this post bellow on the hondata forum website,Īnd if setup properly it would save your engine for mis shifts as you have the limiter set to what your revs fall down to during an up shift,
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |